DIY RV Project – Exterior Utilities Hook-up Light

Click here to view the original post.

Many times you will find yourself trying to hook up the utilities to your RV at dark thirty. Installing an exterior light on your RV will make the task a lot simpler. It doesn’t matter if you are boondocking or hooking up to a park space. You may find yourself in the dark and fumbling around with a flashlight. An exterior light will leave your hands free to make the process of getting things hooked up a lot easier.

Using a $10 light from the local tractor supply outlet and about 8 feet of two strand 12 volt wire is all you need to accomplish this RV mod. The cover for the power cord was removed and a wire was run from the 12 volt connections inside the RV.  A small hole was then made in the side of the RV for the wire after a suitable location for the light was determined. A piece of coat hanger wire was then snaked behind the siding of the RV until it came out at the side of the electrical cord cover opening. The wire was then hooked to the 12 volt electrical wire and pulled through the hole. It was then a simple process of hooking the wires to the light and mounting the base plate to the side of the RV and installing the light cover.

The light included an on/off switch and the cover was mounted with the switch in the down position. Even though the switch was water resistant, mounting it where it was on the bottom helps avoid rain hitting it directly.

It’s a quick and simple RV mod that can be done in less than an hour.

Got RV mod?

Staying above the water line!

Riverwalker